李萨如图形在检测系统中的应用

李萨如图形可以检测两个相同频率信号的相位差．主要论述具有惯性质量、弹簧和阻尼器的二阶加速度测量系统,其动态响应特性的分析方法,如何利用李萨如图形来检测力平衡式加速度传感器的动态特性,即幅频特性和相频特性,从而确定传感器的固有频率ω_n和阻尼比ξ,以此来评定传感器的综合特性．     

充液挠性航天器俯仰运动 1:1:1 内共振动力学分析

采用已推导的俯仰运动矩形贮箱受控刚-液-弹耦合系统在外力矩作用下的耦合动力 学模型，在刚体上加入控制项，详细分析了系统固有频率的精确解与近似解. 应用多尺 度法对耦合系统1:1:1内共振进行解析分析，与数值解比较验证解析解的正确性. 通过近 似解析分析得到刚-液-弹之间的耦合作用机理：1) 液深影响整个系统的软硬特性，当液体发 生软硬特性转化时，处于液体原多值频率区域的刚体和弹性体幅频曲线分支峰值会减弱，且 具有相同的特性转化趋势；处于液体新多值频率区域的刚体和弹性体幅频曲线分支峰值会增 强，且具有相反的特性转化趋势. 2) 刚体和弹性体幅频曲线的峰值均在以受控刚体和弹性体 为主的耦合系统固有频率处，以液体为主固有频率激励，刚体和弹性体振幅较小.     

Regimes of vortex shedding from an in-line oscillating circular cylinder in the uniform flow

A finite volume method for the time dependent viscous incompressible flow around an in-line oscillating circular cylinder at Reynolds number of 200, 855 is presented in this paper. The Navier-Stokes equations in a finite volume form are solved with a moving grid system, based on a time dependent coordinate transformation. To investigate the vortex-shedding characteristics behind the circular cylinder and the effects of Reynolds number and other non-dimensional parameters such as reduced amplitude and reduced frequency， several numerical schemes have been tested with different amplitude and frequency close to Sto and a harmonic at each Reynolds number. Present numerical results indicate several types of vortex shedding mode which is known mainly depending on the reduced frequency and also the reduced amplitude, which is called synchronization or lock-on.     

颗粒在大涡结构中的弥散

气相采用大涡模拟方法,颗粒相采用轨道模型研究了三维后台阶气粒两相湍流流动的大尺度涡结构的瞬时演变过程以及颗粒的瞬时弥散规律.比较了不同入流速度的颗粒在大涡结构中的瞬时弥散特性,尤其研究了高速释放大颗粒的弥散特性.三维流动中大尺度涡结构具有明显的脱离、发展、合并和破碎过程.小颗粒的分布受大涡结构的控制,其空间的弥散过程与流体 大涡结构的空间发展相一致,但是由于三维流动中大涡边缘和中心区的压力差,颗粒在大尺度 涡的边缘出现密集.而大颗粒在流场中的分布受其惯性控制,对气相的涡结构不敏感.高速释放到流场中的大颗粒受惯性影响最大,保持在其原有动量方向上运动.     

斜拉索模态试验参数研究

试验模态分析是斜拉桥索力测试中广泛应用的方法。该方法的关键之一是采取合理的试验方案获取可靠的响应信号以识别出正确的索振动频率。本文通过试验,详细讨论了斜拉索模态测试中若干试验参数,如激振类型、激振位置、传感器位置以及频率分辨率对试验结果的影响;比较环境激励与锤击激励的效果,验证了环境激励的方法也可以准确识别索的频率;最后给出了较为合理的斜拉索模态试验方案,用该方案确定的索力与理论计算结果相差不超过 1. 5%。     

On the spectrum of natural frequencies of circular cylindrical shells completely filled with a fluid

The natural frequencies of cylindrical shells filled with a fluid and having the ends either simply supported or clamped are determined. Conditions are studied under which the natural frequencies of the shell are close or multiple __________ Translated from Prikladnaya Mekhanika, Vol. 42, No. 5, pp. 42–49, May 2006.     

Non-linear vibrations and frequency response analysis of piezoelectrically driven microcantilevers

Microcantilevers have recently received widespread attentions due to their extreme applicability and versatility in both biological and non-biological applications. Along this line, this paper undertakes the non-linear vibrations of a piezoelectrically driven microcantilever beam as a common configuration in many scanning probe microscopy and nanomechanical cantilever biosensor systems. A part of the microcantilever beam surface is covered by a piezoelectric layer (typically ZnO), which acts both as an actuator and sensor. The bending vibrations of the microcantilever beam are studied considering the inextensibility condition and the coupling between electrical and mechanical properties in the piezoelectric materials. The non-linear terms appear in the form of quadratic expression due to presence of piezoelectric layer, and cubic form due to geometrical non-linearities. The Galerkin approximation is then utilized to discretize the equations of motion. In addition, the method of multiple scales is applied to arrive at the closed form solution for the fundamental natural frequency of the system. An experimental setup consisting of a commercial piezoelectric microcantilever attached on the stand of a state-of-the-art microsystem analyzer for non-contact vibration measurement is utilized to verify the theoretical developments. It is found that the experimental results and theoretical findings are in good agreement, which demonstrates that the non-linear modeling framework could provide a better dynamic representation of the microcantilever than the previous linear models. Due to microscale nature of the system, excitation amplitude plays an important role since even a small change in the amplitude of excitation can lead to significant vibrations and frequency shift.     

混合层强化混合的数值研究

受 Ｗａｎｇ ＆ Ｆｉｅｄｌｅｒ（１９９７）的实验的启发，采用高阶精度的差分格式，通过数值模拟的方法，研究了二维混合层及限于两平板间的二维混合层（二维受限混合层）入口处加振动对提高混合层混合效率的作用．计算结果表明：对二维混合层，振动的频率越低，在混合层中产生的大尺度涡结构的尺度越大，在频率很低时，涡具有相似性；对限于两平板间的二维混合层，在一定的振动频率下，混合层中产生的涡较大而且破碎得也较好，这将有利于混合．这一结论与 Ｗａｎｇ ＆ Ｆｉｅｄｌｅｒ（１９９７）的实验观测到的结果是一致的．     

大跨度斜拉桥动力特性分析

本文提出一种计算大距度钢桁梁斜拉桥动力特性的方法。文中分别采用桁段有限单元、空间梁元、空间杆元计算斜拉桥中桁架，桥塔、拉索的刚度矩阵与质量矩阵，采用子空间迭代法求解特征方程，所得结果可供设计参考。     

电磁轴承系统的刚度阻尼特性分析

分析了电磁轴承系统的刚度阻尼特性与系统结构参数及其控制器频响特性之间的关系。给出了系统控制电流的相位对系统稳定性和刚度阻尼特性的影响。提出了电磁轴承系统的复阻尼概念，以及部分刚度阻尼特性指标的实际意义和计算方法。